ANDRIANOS eshop serves orders within Greece.
For overseas shipments, contact our commercial department by email at or at tel: +302721023124
Ventilation systems with heat recovery BLAUBERG SOLO A35 S4 PRO
VENTO SOLO A35 S4 PRO wall ventilator with heat and energy recovery from BLAUBERG is an indoor ventilation system without the need for ducts. Ensures the supply of clean fresh air, with air being alternately extracted and supplied, while at the same time preserving the heat of the room, thanks to its ceramic exchanger with an efficiency of up to 85%. In addition, it ensures a balance in humidity levels in the room thanks to the built-in humidity sensor.
Features:
- Energy class Α.
- Air flow up to 46m3/h.
- Built-in filters with class G3 to clean supply and extract air flows, washable and easily removable.
- Low Power Consumption from 1.20W.
- Control via remote control.
- Reducing the cost of heating in winter and cooling in summer.
- Protect against outdoor noise.
- Prevent penetration of excessive humidity and appearance of mould.
- It does not require condensate drainage.
- The motor has overheating protection and bearings for longer life.
- The air duct can be extended by a pipe of the same diameter at a distance of up to 3m.
- Suitable for replacing an existing fan with minimal intervention.
Remote control
Product cutting VENTO SOLO A35, A50 & A60 V2
VENTO SOLO A35, A50 & A60 V2 installed in the building
Humidity Sensor
Helps control the level of humidity in the room. When the sensor is activated, if the humidity in the room exceeds the set level, the ventilator switches to the second (higher) speed. The humidity sensor threshold can be adjusted by turning the potentiometer knob with a special plastic screwdriver. The humidity sensor can be switched on and off using the remote control.
Regulation is recommended in 65%-70%.